Shiny parts and repetitive patterns might seem like an obvious challenge for many, but with the 2022 Artec Leo, this axle shaft was captured in fine detail in just 10 minutes.
This detailed, high-resolution model of a shiny piece of metal with lots of holes and hard to reach areas was created, start to finish, in a total of about 35 minutes.
Shiny parts with lots of small details, holes, fine lines, and sharp edges are no longer something to fear, as demonstrated in this 3D scan of an engine.
All the thin edges and angled surfaces of the crankcase, together with its individual structural reinforcements, were captured with unmistakable fidelity.
Full of smaller, finer details as well as holes, fine lines, sharp edges, and smooth, possibly shiny surfaces, the dual-clutch gearbox becomes a lot easier to scan with Artec 3D’s new HD mode.
Using the new, AI-powered HD Mode, all the thin edges, including the internal reinforcements, as well as the holes of various diameters, and the long, sweeping curves of the aerodynamic exterior were easily captured.
Hollow areas or surfaces inside the rim that were previously quite tricky to capture in one go have been reconstructed in full detail with no artifacts or noise.
